Chapter 28
| Domain Name Service Commands
– 877 –
ip name-server This command specifies the address of one or more domain name servers to use for
name-to-address resolution. Use the no form to remove a name server from this
list.
Syntax
[no] ip name-server server-address1 [server-address2 …
server-address6]
server-address1 - IPv4 or IPv6 address of domain-name server.
server-address2 … server-address6 - IPv4 or IPv6 address of additional
domain-name servers.
Default Setting
None
Command Mode
Global Configuration
Command Usage
The listed name servers are queried in the specified sequence until a response is
received, or the end of the list is reached with no response.
Example
This example adds two domain-name servers to the list and then displays the list.
Console(config)#ip name-server 192.168.1.55 10.1.0.55
Console(config)#end
Console#show dns
Domain Lookup Status:
DNS disabled
Default Domain Name:
sample.com
Domain Name List:
sample.com.jp
sample.com.uk
Name Server List:
192.168.1.55
10.1.0.55
Console#
Related Commands
ip domain-name (875)
ip domain-lookup (874)
To Next Page
Loading...
