Alarm output: when alarm occurred, system enables peripheral alarm devices.
Tour: Here you can enable tour function when alarm occurs. It is a one-window tour. Please go to
chapter 5.3.9 Display for tour interval setup.
Buzzer: Highlight icon to enable this function. The buzzer beeps when alarm occurs.
Please highlight icon to select the corresponding function. After all the setups please click save
button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in each
channel may not be the same.
In Figure 4-18, you can left click mouse and then drag it to set a region for motion detection. Click AUX
to switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 4-17
Figure 4-18
To Next Page
Loading...
