101 Installation and Service Guide
Installing System Software
3 Remove all external cables from the E-35A.
4 Replace the SATA HDD on the E-35A with the prepared replacement SATA HDD (see page 81).
5 Plug the power cable into the wall power outlet.
6 Start the E-35A (see page 42).
7 Follow the on-screen instructions on the Fiery QuickTouch or monitor.
After installing or updating the system software
1 Restore the dongles and devices that you removed in a previous step.
2 Start the E-35A (see page 42).
3 Install any required software patches by System Updates (see page 102).
4 (Optional) Set up the proxy configuration if you have a proxy server.
In Configure, click Fiery Server > System Updates > HTTP Proxy Settings, and enter the proxy server information.
Save your changes and reboot the E-35A.
You can also enter the proxy server information in System Updates application if a monitor, mouse, and keyboard
are attached to the E-35A.
For more information on setting up proxy configuration, see Configuration and Setup, which is part of the user
documentation.
Verify the E-35A operation
1 Print the Test Page and the Server Configuration page.
If the Test Page does not print, verify that the printer interface cables are securely connected and on the correct
ports, and verify that the printer interface board is securely connected to the motherboard.
If image quality is poor, test the printer (see the service documentation that accompanies the printer).
2 Verify that the E-35A is connected to the network (see page 41).
3 Ask the site administrator to download a test job over the network.
If the job does not print or has poor image quality, see the Troubleshooting topics in Configuration and Setup,
which is part of the user documentation.
Before you leave the customer site
1 Remind the site administrator to do the following:
• Import archived jobs.
Please note that some archived jobs may not print if you have upgraded the E-35A to the newer version.
• (Optional) Register Adobe Acrobat the first time you use it.