31 Installation and Service Guide
Using the E-35A
To access Configure from Command WorkStation
1 In Command WorkStation, as Administrator, do one of the following:
• In the Server menu, click Configure.
• In the Server menu, click Device Center, select General Info tab and then click Configure in the lower right
corner.
2 If the Fiery Setup dialog box displays, click Configure.
Fiery QuickTouch
The Fiery QuickTouch on the front of the E-35A allows you to do the following:
• View print job status and alerts
• Use Fiery System Restore to back up and restore the E-35A
• Replace the motherboard (when the motherboard replacement dongle is inserted into a USB port)
• View the IP address of the E-35A
• Shut down, restart, or reboot the E-35A (see page 41).
• Interact with the E-35A during software installation and initial setup (see page 96)
• Run certain diagnostics (for service purposes only)
To Next Page
Loading...
