18 Installation and Service Guide
Installing Hardware
• The site administrator is responsible for installing the user software shipped with the E-35A onto networked
Windows and Mac OS computers that will print to the E-35A (user documentation is also included).
Note: This document covers hardware installation and service and provides general information about connecting the
E-35A to the customer’s network. Network Setup and configuration information exceeds the scope of this document.
For Network Setup and configuration information, refer the network administrator to Configuration and Setup, which
is part of the user documentation set.
Unpacking the E-35A
The E-35A is assembled and shipped from the factory with all necessary cables (except for the network cable) and
documentation. For shipping contents, see the Packing List.
To unpack the E-35A
It is strongly recommended that you save all packing materials in case you need them later (for example, if you discover
something is damaged and need to return it). Do not immediately discard packing materials.
1 Open the box and remove the packing material.
Save the original boxes and packing material, in case you need to transport the E-35A at a later date.
2 Remove the contents from the top container. Inspect the contents for visible damage.
3 Set aside the remaining components from the top container.
4 Remove the top container and any packing material.
5 Carefully lift the E-35A out of the box.
If you notice shipping damage to any component, save the shipping container, in case the carrier needs to see it.
Call the carrier immediately to report the damage and file a claim.
Let the customer or site administrator know that in order to take full advantage of the E-35A, the user software
must be installed on computers that will print to the E-35A.
Warning: Before you unpack the E-35A, it is strongly recommended that you review all “Precautions” on page 10
to avoid injury or damage to the E-35A.
To Next Page
Loading...
Need help?
General
