Safety
Document ID: OMM-00165 Rev. C Pro 32r Operations Guide 18
2.3.6 Ink System Safety
The ink is heated by printer to its printing temperature. Heater shuts off when the ink reaches the required temperature.
Before using flushing fluid, make sure that the printer is completely cooled down and powered off.
2.3.7 The Emergency Stops
The Printer is equipped with the following emergency stops:
• Emergency buttons
• Emergency cord
• Laser beam
2.3.7.1 The Emergency Stop Buttons
• The printer is equipped with four emergency stops: front right and left, plus rear right and left.
• Push the Emergency button to immediately stop the printer.
• When pushing the Emergency button, The printer stops, the power is cut off, and the pinch rollers open.
• To activate or reactivate printer, all emergency buttons must be released. To release the emergency button, turn it clockwise.
Figure 2-4
Emergency Stop Buttons - Front
Emergency Stop Buttons - Rear
To Next Page
Loading...
