Printer Operations
Document ID: OMM-00165 Rev. C Pro 32r Operations Guide 132
When printing on mesh or other porous media, some measures should be carried out to maintain good print quality and
to protect the print table from excess ink.
Figure 6-37
NOTE: To avoid any damage to the print heads, the carriage must be raised to at least 14mm
before you start the procedures.
1. Before starting to prepare the printer for mesh printing,
go to View > I/O Control.
2. In the Misc Sensors group, find the Mesh Table sensor
display to make sure that the mesh table is working.
When the wings are raised, the display turns green.
3. Raise the wings of the print table by pushing the button
marked Wings, on the front control panel.
4. Turn off the vacuum supply with the vacuum regulator.
6.10 Printing on Mesh
Figure 6-38
To Next Page
Loading...
