Document ID: OMM-00165 Rev. C Pro 32r Operations Guide iv
Table of Contents
1.0 INTRODUCTION 6
1.1 Before Starting 6
1.2 Training 6
1.3 Welcome 6
1.4 Overview 6
1.5 Customer Support Web Site 7
2.0 GENERAL SAFETY 9
2.1 Anti-virus Warning! 9
2.2 Printer-mounted Safety Labels & Components 10
2.3 Potential Hazards 14
3.0 HARDWARE OVERVIEW 22
3.1 General Description 22
3.2 Printer Rollers and Shafts 25
3.3 Ink Systems 27
3.4 Pneumatic System 32
3.5 Electric/Motion Control Panel 35
3.6 Vacuum System 37
3.7 UV LED Curing System 40
3.8 Ionizer (Anti-static Bar) 40
3.9 Front Control Buttons & Vacuum Knob 41
3.10 Roll Tension Control 42
3.11 Purge Buttons 43
3.12 Rear Left Control Button 43
4.0 SOFTWARE OVERVIEW 45
4.1 Front End Window 45
4.2 Front-end Window - Control Panel 46
4.3 Front-end Window – One Job 52
4.4 Front-end Window – Queue 53
4.5 Front-end Window - View Menu 55
4.6 Front-end Window - Tools Menu 63
5.0 PRINTER SETUP 76
5.1 Print Table 76
5.2 Printer Carriage 77
5.3 Cleaning Print Heads 84
5.4 Advanced Fine Tuning 93
5.5 Other Preparations 96
6.0 PRINTER OPERATIONS 105
6.1 EFI Pro 32r Start Up Procedures 105
6.2 Defining Job Settings 106
6.3 Remaining Media 108
6.4 Changing Settings During Printing 111
6.5 Resuming Print 112
6.6 Grouping 114
6.7 Printing with White Ink 116
6.8 Multilayer Printing 121
6.9 Media Handling 126
6.10 Printing on Mesh 132
6.11 Cropping a Job 134
6.12 Multi-Roll Printing (Optional) 137
6.13 Skip White Printing (Optional) 139
6.14 Shutdown Procedure 141
7.0 DOUBLE-SIDED PRINTING (OPTIONAL) 143
7.1 Registration Print Marks 144
7.2 Backlit Printing (Optional) 148
7.3 Blockout Printing 156
8.0 IN-LINE FINISHING (OPTIONAL) 165
8.1 Media Slitters 165
To Next Page
Loading...
Need help?
General
