Eldes ESIM364 - 5. ARMING, DISARMING AND TURNING OFF THE ALARM; 5.1. Free of Charge Phone Call

14
14
EN
ESIM364 USER MANUAL V1.6
5. ARMING, DISARMING AND TURNING OFF THE ALARM
Before arming the system it is necessary to close all doors and windows in the secured area and move yourself away from the motion detec-
tion eld.
Close all
windows
Move away from
motion detection
eld
Close all
doors
Close all
doors
3
NOTE: Your alarm system installer may have enabled a Force attribute for certain zone (-s), thus allowing to arm the system, while the
zone with Force attribute enabled is violated. This event is identied as Partial Arm.
5.1. Free of Charge Phone Call
To arm, disarm the system and turn OFF the alarm, dial the system‘s phone number from any of 10 available user phone numbers
(contact your alarm system installer for user phone number management). The phone call is free charge as the system rejects
it and carries out arming/disarming procedure afterwards. When arming – the system rejects the phone call after 2 rings, when
disarming – the system rejects the phone call immediately. If there is more than one listed user dialling to the system at the
same time, the system will accept the incoming call from the user who was the rst to dial while other user (-s) will be ignored.
When system’s phone number is dialled for arming, the system will proceed as follows:
• Non-partitioned system:
• If ready (no violated zone/tamper), the system will arm.
• If unready (violated zone/tamper is present), the system will not arm and provide a list of violated zones/tampers by SMS text
message to user phone number. In such case the user must restore all violated zones and tampers before arming the system.
Alternatively, the violated zones can be bypassed (see 8. BYPASSING AND ACTIVATING ZONES), disabled (please contact your alarm
system installer to set up this parameter) or a Force attribute enabled (resulting in partial arm; please contact your alarm system installer
to set up this parameter), while the tampers can be disabled (please contact your alarm system installer to set up this parameter).
• Partitioned system:
• If all partitions are disarmed ready, the system will arm them.
• If one or more partitions are disarmed unready (violated zone/tamper is present), the system will arm the ready partition (-s) and
skip the unready one (-s). The system will then send an SMS text message, containing a list of violated zones/tampers, to user
phone number that the system arming was initiated from.
• If a combination of armed and disarmed ready partitions is present, the system will arm the disarmed ready partitions and skip the armed
ones.
When a user phone number is assigned to multiple partitions, the user will be able arm/disarm the corresponding system partitions by dialling the sys-
tem’s phone number. For example, if User 1 is assigned to Partition 1, 2 and 3, the user will be able to arm/disarm Partition 1, 2 and 3 by a single phone
call to the system from User 1 phone number. For more details on how to set user phone number partition, please contact your alarm system installer.
NOTE: Your alarm system installer may have disabled
system arming and/or disarming by free of charge phone
call and SMS text message for a certain user.
User
ESIM364
CALL
4
By default, all listed user phone numbers are granted with permission to arm and disarm the system by free of charge phone call and SMS
text message. To disable/enable arming or disarming for certain listed user phone numbers, please refer to the following conguration
method.