Technical Support - MDM 28/97 599 76 11-68 Rev. 01
6 DIAGNOSTIC SYSTEM
6.1 Accessing diagnostics for TC3 styling
The operations listed below must be carried out within 7 seconds.
Do not start the procedure with your fingers over the combination sensors
1. Switch on the appliance using the ON/OFF button. The first LED lights up.
2. Touch the START/PAUSE and the nearest option sensor simultaneously (as shown in
the figure).
3. Hold your fingers over the sensors until the LEDs and symbols begin to flash in sequence
(approximately 3 seconds).
In the first position, the operation of the sensors, of the LEDs and of the groups of symbols shown on
the LCD screen is tested; turn the programme selector dial clockwise to run the diagnostic cycle for
the operation of the various components and to read any alarms (see diagnostic test on the following
page).
6.2 Accessing diagnostics for TC4 styling
Do not start the procedure with your fingers over the combination sensors
1. Set the selector dial to position 0 (zero).
2. Rotate the programme selector by one position clockwise.
3. Simultaneously press the START/PAUSE button and the nearest option sensor (as shown in
the diagram).
4. Keep your fingers above the sensors until the LEDs and display symbols start flashing.
In the first position, the operation of the sensors and the related LEDs is checked; turn the
programme selector dial clockwise to run the diagnostic cycle for the operation of the various
components and to read any alarms (see diagnostic test on the next page).
6.3 Quitting the diagnostics system
To exit the diagnostic cycle, switch the appliance off then back on:
For TC3 styling press the ON/OFF push button, while for TC4 styling rotate the knob to 0 (zero).
If “electricity trials” appears on the screen when you turn the appliance on, repeat the operation of turning
it on and off.
To Next Page
Loading...
