3-7
CRUSHER
SWITCH
WATER/CUBE
SWITCH
LOCK
SWITCH
Checking and Replacing the Actua-
tor Switch:
1. Disconnect the unit from the power
source.
2. Perform steps 1 through 6 of To Re -
move Ice and Water Fountain Bracket
Assembly.
3. Check the continuity of the switch if
defective go to step 4.
4. Remove the mounting screw.
5. Remove the switch.
6. Remove the wire leads.
7. Install new switch in reverse order of
removal.
Fountain Heater
(A fountain heater is used on all dispenser
models).
The fountain heater is used to evaporate
any moisture that might accumulate from
condensation. It is bonded to self-adhesive
aluminum foil which is shaped to fit the out-
side of the fountain housing.
1. Disconnect the unit from the power
source.
2. Remove the ice and water fountain
bracket assembly as discussed earlier.
3. Disconnect the electrical quick
disconnect.
4. Check for resistance between the red
wire with the black tracer and the white
wire on the fountain housing, quick dis-
connect electrical connector.
5. If the fountain heater reads open, go to
step 5.
6. Remove the door from the unit and dis-
assemble liner and the gasket.
7. Carefully remove the foam seals and
disconnect the heater wire terminals.
8. Pull the foil heater backing from the
fountain.
9. Reassemble the parts in reverse order
of removal.
LIGHT
SWITCH
To Next Page
Loading...
