ELNA eXpressive920 - Printed Circuit Board K

11
Printed circuit board K
NOTE:
Do not disconnect the connectors by pulling on cord.
To disconnect the connectors, grasp the connector, not the
cord.
To remove:
1. Remove the front cover (see page 5).
2. Disconnect the connectors from the circuit board K.
3. Remove the setscrews (3 pcs), and the circuit board K.
To attach:
Follow the above procedure in reverse.
Replacing Electronic Components
Circuit board K schematic
Printed circuit board F
Printed circuit board L1
Slide volume
Printed circuit board L2
Printed circuit board
A relay 6-pin)
Printed circuit board
A relay (26-pin)
Printed circuit board
A relay (30-pin)
Setscrew
Setscrew