ELNA eXpressive920 - Replacing Y-Belt

63
Mechanical Adjustment
ReplacingY-belt
•RemovingY-belt
z
Remove the hexagonal socket screw q.
Slide the stopper in the direction of arrow.
x Remove the setscrews w.
c Remove the setscrews e.
v Remove the Y-belt.
wwwww
q
e
e
•AttachingY-belt
n
Attach the Y-belt.
r
n Be sure that the Y-belt deflection to about 3 mm by
pressing the middle of Y-belt with approximately 30 grams
of pressure.
If not, turn the Y-carriage upside down.
Loosen the nut r, and turn the eccentric pin to adjust the
belt tension, then tighten the nut.
m Follow the “removing Y-belt” procedure in reverse.