ELNA eXpressive920 - Carriage Adjustment (Backlash of Y-Carriage)

64
Mechanical Adjustment
Y-carriageadjustment
If there is a play at Y-carriage, follow the procedure
below.
z Push down the carriage arm release lever q.
Extend the carriage arm. Swing out the carriage arm
until it locks in fully extended position.
x Turn the embroidery unit upside down.
Remove the cover
w.
q
w
c
Move the Y-carriage e under the hole r.
r
e
t
u
y
v
Hook a slotted driver to the hole t.
To tighten the carriage, move the fin-shaped metal to
the direction of arrow
y.
To loosen the carriage, move the fin-shaped metal to
the direction or arrow
u.
Be sure that there is no play at the Y-carriage.
Attach the cover
w.