Emerson Daniel 3410 Series User Manual

3410 Series Gas Ultrasonic Meters Operations Manual Section 2: Setup meter communications
3-9000-777 Rev E January 2018
Daniel MeterLink utilities 3
21
Section 2: Setup meter communications
After the installation of your Daniel Ultrasonic Meter, install Daniel MeterLink
TM
on your PC or
laptop as described in the Daniel MeterLink Software for Gas and Liquid Ultrasonic Flow Meters
Quick Start Manual (P/N 3-9000-763) for your operating system (Windows® 2000, Windows®
Vista, Windows® 7 or Windows® 8), then configure the meter.
The installation CD is made available with the Daniel MeterLink
Software for Gas and Liquid
Ultrasonic Flow Meters Quick Start Manual (P/N 3-9000-763) located inside the back cover.
The Daniel MeterLink installation program is available for download from the Daniel
Measurement and Control, Inc. website:
http://www.daniel.com/um2.htm
2.1 Daniel MeterLink utilities
Daniel MeterLink provides the following utilities to configure the meter’s flow measurement
units, meter output parameters, communications settings, output tests and logs and reports
file management.
• Field Setup Wizard
- Startup
- General
- Frequency/Digital Output Sources
- Frequency Outputs
- Meter Digital Outputs
- Current Outputs
- HART® Outputs
- Meter Corrections
- Temperature and Pressure
- Gas Chromatograph Setup
- AGA8
- Continuous Flow Analysis
- Local Display
• Tools
- Edit/Compare Configuration
- Waveform Viewer
- SOS Calculator
- Outputs Test
- Transducer Swap-Out
- Program Download
- Communications Analyzer

Emerson Daniel 3410 Series Specifications

General

Brand	Emerson
Model	Daniel 3410 Series
Category	Measuring Instruments
Language	English