6-15
a. Enter Operating Pressure Range and Units.
b. Enter Operating Temperature Range and Units.
7. (Optional) If desired, modify standard pressure and/or temperature
conditions. (These values only apply if flow units are set to: StdCuft/s,
StdCuft/min, StdCuft/h, StdCuft/d, StdCum/h, or StdCum/d.)
8. Select Next.
9. If you selected an AIChE database fluid, this screen is already
populated with AIChE data. If desired, this data may be edited.
However, if a change is made to either a density or viscosity value,
the EA considers the fluid to be “Custom Fluid.”
If you entered a custom fluid, fill in the compressibility/density
column, the viscosity column, the molecular weight, the
isentropic exponent, and the standard density.
10. Select Flow U
nits.
11. Select Finished.
Figure 6-7.
Compressibility and Viscosity Table
(Gas Configuration).
NOTE
Table values automatically convert
if a different unit of measure is
selected.
All data fields can be edited.
To Next Page
Loading...
