4. Choose Configure/Setpoint.
5. Choose Alarm 1, Alarm 2, Alarm 3, or Alarm 4.
The screens summarizes the present configuration and setpoints. There are nine
items: Setpoint, Assign (S1 is sensor 1 and S2 is sensor 2), Logic, Deadband, Interval time,
On time, Recover time, and Hold while active. The last four items describe the operation of
the timer. Only four items are shown at a time. To view the remaining items, scroll
to the bottom of the screen and continue scrolling.
6.
To make a change, move the cursor to the desired line and press ENTER.
A screen appears in which the present setting can be edited.
7. Press ENTER to store the setting.
For an explanation of terms, see Section 7.4.1 and Section 7.4.2.
8. To return to the main display, press MENU and then EXIT.
Programming the transmitter
Instruction Manual 49
To Next Page
Loading...
