EasyManua.ls Logo

EMKO TRANS MINI AUTO - Event Log Display Pages on the LCD Display

EMKO TRANS MINI AUTO
61 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EventLogPage2:
1.2:
Fq:
kW:
Oiloressure:
Temp:
Thesecondpageofrelatedeventlog
Generatorfrequency
Generatortotalactivepower
Oilpressuresenderinputvalue
Temperaturesenderinputvalue
EVENTLOG1.2
Fq:50.0HzkW:510
Oilpressure:4.3bar
Temperature:30ºC
EventLogPage3:
1.3:
Conf. AI:
Thelastpageofrelatedeventlog
Configurable AnalogInputvalue
EVENTLOG1.3
Conf.AI:96%
EventLogPage1:
1.1:
Emergencystop:
V1:
I1:
Thefirstpageofrelatedeventlog
Thismessageindicatesthatanemergencystop
alarmhasoccurred.(Eventhistory:15/02/2011date,14:26:08
time).
GeneratorvoltageL1-N
LoadCurrentL1
EVENTLOG1.1
15/02/201114:26:08
Emergencystop
V1:220VI1:26A
INPUT&OUTPUT
1458
Inputs:000XXXXX
Outputs:000000XX
Onload
Input&OutputStatusPage:
Inputs:
1: 2: 3: 4:
5: 6: 7: 8:
Outputs:
1: 2: 3: 4:
5: 6: 7: 8:
Inputstatusinformation.Ifaninputisactive,relateddigit
isdisplayedas"1"elseitisdisplayedas"0".
Conf.in-1, Conf.in-2, Conf.in-3, Notavailable,
Notavailable, Notavailable, Notavailable, Notavailable
Outputstatusinformation.Ifanoutputisactive,related
digitisdisplayedas"1"elseitisdisplayedas"0".
Conf.out-1, Conf.out-2, Conf.out-3, Conf.out-4,
Conf.out-5, Conf.Out-6, Notavailable, Notavailable.
DATE&TIME
15/02/2011
13:32:28
Date& TimePage:
Date:
Time:
Day,Month, Year.
Hour,minute,second.
11
Note: *
2
= TheseJ1939pageisonlyavailableat Trans-MiniAUTO.CAN
J1939DM1FAULTS1
Spn:110
Fmi:0Oc:1
CoolantTemper.sensor
Valuetoohigh
J1939DM1(Active)FaultsPage:
Spn:
Fmi:
Oc:
Suspectparameternumber(e.g.SPN=110correspondsto
coolanttemperaturesensor)
Failuremodeidentifier(e.g.FMI=0meansvaluetoohigh)
Occurrencecount(ifOC=0,noalarmispresent)
Thefirst10activealarmmessages(ActiveDiagnostic Trouble
Codes-DM1)withSPN,FMI,andOCaredisplayed).Ifmorethan
oneactivefaultconditionispresent,allofthemisdisplayed
sequencelybypressingNextandPreviousbuttons.
*
2
EventLogdisplaypagesontheLCDdisplay;

Table of Contents

Related product manuals