Endress+Hauser Deltabar FMD72 - Connecting HP Sensor Module to Transmitter

Deltabar FMD71, FMD72 Electrical connection
Endress+Hauser 25
6.1.1 Screening with cable shield
Screening with cable shield is described in the associated documentation SD00354P. The
documentation is provided with the connecting cables.
6.2 Connecting the sensor module HP to the transmitter
L
WARNING
Supply voltage might be connected!
Risk of electric shock and/or explosion!
‣
Switch off the supply voltage before connecting the device.
• Screw on the housing cover of the terminal compartment of the sensor module HP.
• Guide the cable of the transmitter through the cable gland of the sensor module HP. Use
the shielded 4-wire cable that is provided. The wire ends are color-coded to match the
corresponding terminal.
• Connect device in accordance with the following diagram.
• Screw down housing cover.
6
5
5
7
2 3 4
3
4
1
21
6
5
NPT ½"
M20
8
8
A0017529
1 BK (black)
2 BU (blue)
3 WH (white)
4 BN (brown)
5 Sensor module HP
6 Transmitter
7 Ground terminal
8 Torque 0.4 Nm
6.2.1 Screening with cable shield
Screening with cable shield is described in the associated documentation SD00354P. The
documentation is provided with the connecting cables.