Endress+Hauser Ecograph RSG35 - Page 148

Appendix Ecograph T, RSG35
148 Endress+Hauser
Options Please select, Universal input x, Digital input x, Maths x, Set point x, Relay x
All active inputs are available for selection.
Factory setting Please select
"Limits" submenu
Navigation Expert → Application → Limits
Description Limit values can monitor the measured values. A relay, for example, can be switched if a
limit value is violated.
Add limit value
Navigation Expert → Application → Limits → Add limit value
Direct access code: 450300-000
Description Adding a new limit value.
Options No, Yes
Factory setting No
Delete limit value
Navigation Expert → Application → Limits → Delete limit value
Direct access code: 450301-000
Description Deleting a limit value from the list.
Options No, limit value x
Factory setting No
"Set point x" submenu
Navigation Expert → Application → Limits → Limit x
Description View or change the setup for the selected alarm set point.
x = place holder for selected limit value
Channel/value