Ecograph T, RSG35 Appendix
Endress+Hauser 147
Description For the set time frame, determines the minimum, maximum and average value or
quantities and operating times.
If the "Externally controlled" option is to be used, a digital input or a maths channel
must be set to "Function = Control input" and "Action = Start/stop analysis x".
Only analysis 1 can be configured; analyses 2-4 are permanently set to daily analysis,
monthly analysis and annual analysis
Options Switched off, Externally controlled, 1min, 2min, 3min, 4min, 5min, 10min, 15min, 30min,
1h, 2h, 3h, 4h, 6h, 8h, 12h
Factory setting Switched off
Synchron. time
Navigation Expert → Application → Signal analysis → Synchron. time
Direct access code: 440004-000
Description Time for completing the signal analysis.
If, for example, 07:00 is set up then the daily analysis will run from 07:00 on the current
day until 07:00 on the following day.
User entry Time
Factory setting 00:00
Reset to zero
Navigation Expert → Application → Signal analysis → Reset to zero
Direct access code: 440007-000
Description Reset analysis.
Note: should only be executed after the device has taken over the setup.
Options Please select, Analysis x, Totalizer, All
Factory setting Please select
Reset channel
Navigation Expert → Application → Signal analysis → Reset channel
Direct access code: 440010-000
Description Reset analysis of a single channel.
Note: should only be executed after the device has taken over the setup.
To Next Page
Loading...