Endress+Hauser Levelflex FMP54 - Page 169

Levelflex FMP51, FMP52, FMP54 FOUNDATION Fieldbus Operating menu
Endress+Hauser 169
Interface distance
Navigation  Setup → Interface dist.
Prerequisite Operating mode (→  159) = Interface or Interface with capacitance
Description Displays the measured distance D
I
between the reference point (lower edge of flange or
threaded connection) and the interface.
Additional information
D
I
D
I
A0013202
The unit is defined in the Distance unit parameter (→  159).
Confirm distance 
Navigation  Setup → Confirm distance
Description Specify, whether the measured distance matches the real distance.
Depending on the selection the device automatically sets the range of mapping.
Selection • Manual map
• Distance ok
• Distance unknown
• Distance too small
*
• Distance too big
*
• Tank empty
• Delete map
Factory setting Distance unknown
* Visibility depends on order options or device settings