Endress+Hauser Levelflex FMP55 HART - Full Calibration

Operating menu Levelflex FMP55 HART
114 Endress+Hauser
Additional information
0%
E
E
0%
A0013177
 26 Empty calibration (E) for interface measurements
In the case of interface measurements the Empty calibration parameter is valid for
both, the total and the interface level.
Full calibration 
Navigation  Setup → Full calibr.
Description Specify the distance F between the minimum level (0%) and the maximum level (100%).
User entry Depending on the probe
Factory setting Depending on the probe
Additional information
0%
F
F
0%
100%
100%
A0013188
 27 Full calibration (F) for interface measurements
In the case of interface measurements the Full calibration parameter is valid for
both, the total and the interface level.