Endress+Hauser Levelflex FMP55 HART - Intermediate Height

Operating menu Levelflex FMP55 HART
138 Endress+Hauser
Intermediate height 
Navigation  Setup → Advanced setup → Linearization → Intermed. height
Prerequisite Linearization type (→  134) has one of the following values:
• Pyramid bottom
• Conical bottom
• Angled bottom
Description Specify intermediate height H.
User entry 0 to 200 m
Factory setting 0 m
Additional information
0%
H
A0013264
H Intermediate height
The unit is defined in the Distance unit parameter (→  111).
Table mode 
Navigation  Setup → Advanced setup → Linearization → Table mode
Prerequisite Linearization type (→  134) = Table
Description Select editing mode of the linearization table.
Selection • Manual
• Semiautomatic
• Clear table
• Sort table
Factory setting Manual