Endress+Hauser Levelflex FMP55 HART - Automatic DC Calculation; DC Value; Manual Thickness Upper Layer; Use Calculated DC Value

Operating menu Levelflex FMP55 HART
130 Endress+Hauser
"Automatic DC calculation" wizard
The Automatic DC calculation wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the
automatic DC calculation are located directly in the Interface submenu (→  124)
In the Automatic DC calculation wizard two parameters are displayed simultaneously
on the display module at any one time. The upper parameter can be edited, whereas
the lower parameter is displayed for reference purposes only.
Navigation  Setup → Advanced setup → Interface → Autom. DC calc.
Manual thickness upper layer 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → Man.thick.up.lay
Description →  127
DC value 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → DC value
Description →  128
Use calculated DC value 
Navigation  Setup → Advanced setup → Interface → Autom. DC calc. → Use calc. DC
Description →  129