SD01189C/07/EN/04.17
Endress+Hauser
67
8.6.3 Sensor Disinfection (Input, FC: 04)
Current sensor-diagnosis : time of diagnosis apperance
Manufacturing date of the sensor
Initial-operation date of sensor
Date of the last successful slope calibration of the sensor
Date of the last successful zero point calibration of the sensor
Difference of slope between current and last calibration
Difference of zero point between current and last calibration
Min. measured temperature value
Max. measured temperature value
Operating hours of connected sensor
Number of sensor-cap calibrations
Current sensor-diagnosis : diagnosis code
Current sensor-diagnosis : status according to NAMUR NE107
Selected sensor type. The selected type has to match with the
connected sensor type.
Selection:
0: None (default)
1: Oxygen (amp.)
2: Oxygen (opt. fixed cable)
3: pH Glass
4: pH/ORP
5: pH ISFET
6: Cond c
7: Cond i
8: ORP
9: TU/TS
10: Nitrate
11: ISE
12: SAC
13: Ultrasonic interface
14: Chlorine
18: pH/ORP
19: Cond c 4-pol
20: Oxygen (opt. Memosens coupling)
21: TU
22: Inline photometer
Number of clean in place cycles
Number of sterilisation cycles for cap
Number of clean in place cycles for cap
Number of autoclavings for cap
Operating hours above a temperature of T3
Cap operating hours of connected sensor
Cap operating hours above a temperature of T1
Cap operating hours above a temperature of T2
Cap operating hours above a temperature of T3
Cap operating hours raw value above T4
Cap operating hours raw value above T5
Temperature threshold T1 for operating hours counter