Endress+Hauser Liquiline CM44 series - Page 73

SD01189C/07/EN/04.17
Endress+Hauser
73
Register
Data Type
Bytes
R/W
Unit
Description
29
UNSIGNED8
1
R
None
Calibration method
Selection:
0: None (default)
1: Numeric input
2: 1-point calibration
3: 2-point calibration
4: Multipoint Calibration
5: Table
7: Zero point
8: Slope air
9: Slope H2O
10: Slope variable
11: Zeropoint reference
12: Slope reference
13: Offset
14: Slope
15: with temp. comp
16: without temp. comp
17: Standard addition
18: Numeric input slope
19: Numeric input zero point
20: Numeric input 2-point
21: Factory calib.
22: Slope test gas
23: Value acquisition
30
UNSIGNED16
2
R
None
Number of calibrations
31
UNSIGNED16
2
R
None
Current sensor-diagnosis : diagnosis code
32
UNSIGNED8
1
R
None
Current sensor-diagnosis : status according to NAMUR NE107
33
UNSIGNED8
1
R
None
Selected sensor type. The selected type has to match with the connected
sensor type.
Selection:
0: None (default)
1: Oxygen (amp.)
2: Oxygen (opt. fixed cable)
3: pH Glass
4: pH/ORP
5: pH ISFET
6: Cond c
7: Cond i
8: ORP
9: TU/TS
10: Nitrate
11: ISE
12: SAC
13: Ultrasonic interface
14: Chlorine
18: pH/ORP
19: Cond c 4-pol
20: Oxygen (opt. Memosens coupling)
21: TU
22: Inline photometer
34
FLOAT
4
R
None
Raw value