Operation Liquistation CSF48
138 Endress+Hauser
Deactivation Options
• Bottles full
• Enable invalid
• Deactivation with event
Factory setting
Enable invalid
Select the disable function of the subprogram:
Bottles full
The subprogram is disabled once all the assigned
bottles have been filled.
Enable invalid
Disable via limit value
Deactivation with event
New parameter can be defined
Bottle change mode Options
•No
•Yes
Factory setting
Yes
No:
The bottle is changed following a disable/enable
Yes:
When the cycle is finished, the system continues
filling the last bottle.
Synchronize samplings Options
• To subprogram start
•To clock
Factory setting
To subprogram start
To subprogram start
The intervals defined in the sampling mode are
enabled when the subprogram is started.
To clock
The intervals defined in the sampling mode are
enabled after a specific time.
For example, if 30 min is entered this means that the
interval is only activated at a time of xx:30.
--> You configure this time in the "Offset
synchronization" menu item.
Bottle synchronization Options
•None
• 1. bottle change time
• 1. Time of change + bottle
number
• External BC sync input
Factory setting
None
Specific bottles can be assigned specific filling times
with the bottle synchronization function.
For example, bottle 1 is to be filled from midnight to
2 a.m., bottle 2 from 2 a.m. to 4 a.m. etc..
None
The time of sampling and bottle change are not
synchronized.
1. bottle change time
Sampling starts with the first bottle. The changeover
to the next bottles is synchronized.
1. Time of change + bottle number
A specific fill time is assigned to each bottle.
External BC sync input
The system changes to the next bottle when an
external signal is received. The external signal first
has to be configured via the binary input. The binary
input can then be selected as the source.
Assignment bin. output Options
• No binary output configured
• Binary output S:x
Factory setting
No binary output configured
Assignment of the binary output to the program
cycle.
Use "SAVE" to save the subprogram setup. Then press "ESC" to return to the main program.
Path: Menu/Setup/Sampling programs
Function Options Info
To Next Page
Loading...
