Liquistation CSF48 System integration
Endress+Hauser 59
7.2.3 Operation
• In the DTM the menu structure corresponds to the onsite operation. The functions of the
Liquistation soft keys are located on the left in the main window. Here is where you also
navigate through the software.
• Clicking a menu name or a function corresponds to pressing the navigator.
• You can make your settings conveniently via the computer keyboard.
• Via Fieldcare, you can save logbooks, make backups of configurations and transfer the
configurations to other devices.
• To start exporting the logbook click "Operating devices", "Device functions" and "Further
functions". Select ".dat" to save the file in a protected format for processing with the Field Data
Manager.
• You can also print out configurations or save them as PDFs.
7.3 Fieldbuses
7.3.1 HART
You can communicate via current output 1 using the HART protocol.
‣ Connect the HART modem or handheld to current output 1 (communication load 230 - 500
Ohm).
‣ Establish the connection via your HART device.
‣ Operate Liquistation via the HART device. To do so, follow the instructions in the manual.
All the information on HART communication is provided on the CD (--> BA00486C).
7.3.2 PROFIBUS-DP
With the fieldbus module 485 and the appropriate device version, you can communicate via
PROFIBUS DP.
Connect the PROFIBUS data cable to the terminals of the fieldbus module as described ä 52.
All the information on PROFIBUS communication is provided on the CD (SD01188C).
7.3.3 Modbus
With the fieldbus module 485 and the appropriate device version, you can communicate via
Modbus RS485 or Modbus TCP.
The RTU and ASCII protocols are available when connecting via Modbus RS485. You can switch
to ASCII on the device.
Connect the Modbus data cable to the terminals of the fieldbus module (RS 485) or to the RJ45
(TCP) port as described ( ä 52).
All the information on Modbus communication is provided on the CD (SD01189C).
To Next Page
Loading...
