Liquistation CSF48 Operation
Endress+Hauser 73
10 Operation
10.1 Display
10.1.1 Measuring mode
To display the measuring values go to "Measurement" in the general overview or press the
"MEAS" soft key when a program is running.
There are various display modes:
(Press the navigator button to change the mode)
1. Channel overview
The names of all the channels, each sensor type connected and the current primary values
are shown on the display.
2. Primary value of the selected channel
The name of the channel, the sensor type connected and the current primary value are
shown on the display.
3. Primary and secondary measured value of the selected channel
The name of the channel, the sensor type connected and the current primary and
secondary value are shown on the display.
There is a special function for temperature sensor 1. The status of the compressor,
ventilator and heating are displayed (on/off).
4. All the measured values of all the inputs and outputs
The current primary and secondary value, as well as all the raw values, are shown on the
display.
5. User-definable screens
You configure what values you want to display. You can choose from all the measured
values of physical and "virtual" sensors (calculated using mathematical functions) and
output parameters.
In the first 3 modes, you can switch between channels by turning the navigator. In addition
to having an overview of all the channels, in the 4th mode you can also select a value and
press the navigator to see more details for the value. You can also find your user-defined
screens in this mode.
To Next Page
Loading...
