Endress+Hauser Liquistation CSF48 - Page 74

Operation Liquistation CSF48
74 Endress+Hauser
10.1.2 Device status
Icons on the display alert you to special device conditions.
If two or more diagnostics messages occur simultaneously, only the icon for the message
with the highest priority is shown on the display (for the order of priority according to
NAMUR, see the "Changing diagnostic information" section).
10.1.3 Assignment views
"Assignment views" appear as the last function in many sections of the menu, e.g. Channel
assignment view.
You can use this function to see what actuators or functions are connected to or a sensor
channel.
The assignments appear in hierarchical order.
Icon Location Description
Title bar Diagnostics message "Failure"
Title bar Diagnostics message "Maintenance request"
Title bar Diagnostics message "Check"
Title bar Diagnostics message "Out of specification"
Title bar Fieldbus or TCP/IP communication active
Title bar Hold active
At measured value Hold for the actuator (current output, limit contactor etc.) is active
At measured value
1)
1) Only pH or ORP measurement
An offset has been added to the measured value
At measured value Measured value has status "Bad" or "Alarm"
At measured value Automatic temperature compensation active
At measured value Manual temperature compensation active
Title bar Simulation mode active or Memocheck SIM connected
At measured value The measured value is influenced by a simulated value
At measured value The displayed measured value is simulated