Endress+Hauser Liquistation CSF48 - Output

Technical data Liquistation CSF48
250 Endress+Hauser
15.5 Output
15.5.1 Output signal
2 binary outputs (standard) + 2 binary outputs (optional):
Open collector, max. 30 V, 200 mA
Depending on version (optional):
2 to 6 x 0/4 to 20 mA, active, galvanically isolated from the sensor circuits and from each other
Of those, 1 x with optional HART communication (only via current output 1:1). Limited to 2
current outputs with optional fieldbus communication.
15.5.2 Communication
• 1 service interface
• Accessible via front panel connection (optional)
• Commubox FXA291 (accessory) required for communication with the PC
15.5.3 Output signal
HART
PROFIBUS DP
Signal encoding FSK ± 0.5 mA via current signal
Data transmission rate 1200 Baud
Galvanic isolation Yes
Load (communication resistor) 250 
Signal encoding EIA/TIA-485, PROFIBUS-DP-compliant as per IEC 61158
Data transmission rate 9.6 kBd, 19.2 kBd, 45.45kBd, 93.75 kBd, 187.5 kBd, 500 kBd, 1.5 MBd,
6MBd, 12MBd
Galvanic isolation Yes
Connector Spring terminal (max. 1.5 mm), bridged internally (T-function)
Bus termination Internal slide switch with LED display