Liquistation CSF48 Installation
Endress+Hauser 23
5.2 Erecting the sampler
5.2.1 Connecting the suction line from the side for version with pump
1. Observe the installation conditions when installing the device.
2. Route the suction line from the sampling point to the sampler.
3. Screw the suction line onto the suction line connection of the sampler.
5.2.2 Connecting the suction line from below for version with pump
If the suction line is connected from below, the suction line is routed upwards behind the rear
panel of the sample compartment. First remove the rear panel of the dosing chamber and
sample compartment as described in the "Wiring" section.
1. Remove the drain plug from the hose gland located at the back of the sampler base.
2. As illustrated, guide the suction line upwards and through the opening towards the front.
a0013704
Fig. 13: Sample supply from below
1
2
Gland for the suction line
Suction line
To Next Page
Loading...
