Diagnostics and troubleshooting Liquistation CSF48
214 Endress+Hauser
11.13 Term information
The following information is displayed:
• Operating hours device:
Displays the total operating hours of the device in days, hours and minutes
• Operating hours cooling (only for the version with a climate control module):
Displays the total operating hours of the compressor in days, hours and minutes
• Overfill sensor (for version with vacuum pump):
Number of times a safety switchoff has been caused by LF2
• Dosing valve (for version with vacuum pump):
Number of times the dosing valve is actuated; -> corresponds to the number of samples taken
• Vacuum pump (for version with vacuum pump):
Displays the pump operating time in hours and minutes
• Sample totalizer (for version with peristaltic pump):
Number of all samples taken and sample errors
• Pump tube life (for version with peristaltic pump):
Displays how old the tube is in days, hours and minutes
This counter must be reset when a tube is replaced.
• Inline armature (for version with sampling assembly):
Number of all samples taken.
Set the specific counter reading to zero with "Reset".
11.14 Status of inputs/outputs
Path: Display/Operation/Measurement
The following measured values are listed (read only):
•Binary inputs
Current function state: on or off
• Current inputs
Actual current values of all the current inputs available
• Alarm relay
Current function state: on or off
•Binary outputs
Current function state: on or off
• Temperature sensors
Current value is displayed: S:1 (cooling system)
• Current outputs (for version with sensors with the Memosens protocol)
Actual current values of the current outputs
To Next Page
Loading...
