Endress+Hauser Liquistation CSF48 - Page 36

Electrical connection Liquistation CSF48
36 Endress+Hauser
6.2.7 Cable terminals
Plug-in terminals for Memosens and PROFIBUS/RS485 connections
After connection, make sure that every cable end is securely in place. Terminated cable
ends, in particular, tend to come loose easily if they have not been correctly inserted as far
as possible.
All other plug-in terminals
Single-wire, multi-wire and fine-wire cables can be used for the connection, with and
without ferrules. Only one wire is permitted per terminal.
a0012691
Fig. 31: Press the screwdriver against
the clip (opens the terminal)
a0012692
Fig. 32: Insert the cable until the limit
stop
a0012693
Fig. 33: Remove the screwdriver (closes
the terminal)
a0012694
Fig. 34: Insert the screwdriver (opens
the terminal)
a0012695
Fig. 35: Insert the cable until the limit
stop
a0012696
Fig. 36: Remove the screwdriver (closes
the terminal)