Endress+Hauser Liquistation CSF48 - Page 46

Electrical connection Liquistation CSF48
46 Endress+Hauser
6.5.3 Sensor connection
Before you connect a sensor to the controller, you must first route it via the back panel to the
controller housing towards the front. See the "Removing the rear panel of the dosing
compartment" and the "Removing the rear panel of the sampling compartment" sections.
If possible, only use terminated genuine cables.
a0003350
Fig. 56: Memosens data cable CYK10
a0016360
Fig. 55: Gland to the controller