PROline Promass 80 8 Accessories
Endress+Hauser 59
8 Accessories
Various accessories, which can be ordered separately from Endress+Hauser, are
available for the transmitter and the sensor. The E+H service organisation can provide
detailed information on the order codes of your choice.
Accessory Description Ordering code
Transmitter
Promass 80
Transmitter for replacement or for stock. Use
the order code to define the following
specifications:
–Approvals
– Degree of protection / version
– Cable entries
– Display / power supply / operation
– Software
– Outputs / inputs
80XXX
− XXXXX * * * * * *
Installation set for
transmitter
Mounting set for remote version. Suitable for:
– Wall mounting
– Pipe mounting
– Installation in control panel
DK8WM
− *
Post mounting set for
the Promass A sensor
Post mounting set for the Promass A DK8AS
− * *
Mounting set for the
Promass A sensor
Mounting set for Promass A, comprising:
– 2 process connections (see Page 138 ff.)
– Seals
DK8MS
− * * * * * *
Set of seals for sensor For replacement of the seals of the Promass M
and Promass A sensors.
Set consists of two seals.
DKS
− * * *
HART Communicator
DXR 375 handheld
terminal
Handheld terminal for remote
parameterisation and for obtaining measured
values via the current output HART
(4...20 mA).
Contact your E+H representative for more
information.
DXR375
− * * * * * *
Applicator Software for selecting and configuring
flowmeters.
Applicator can be downloaded from the
Internet or ordered on CD-ROM for installation
on a local PC.
Contact your E+H representative for more
information.
DKA80
− *
FieldTool Configuration and service software for
flowmeters in the field:
– Commissioning, maintenance analysis
– Configuring flowmeters
– Service functions
– Visualisation of process data
– Trouble-shooting
– Controlling the “FieldCheck”
tester/simulator
Contact your E+H representative for more
information.
DXS10
− * * * * *
To Next Page
Loading...
