Function group
DISPLAY
RESET
TOTALIZER
The totalizer can be reset to “Zero” in this function.
Note!
• The overflow as well as the totalizer value in the HOME position are reset
to zero.
• If the Promag 33 measuring electronics are fitted with a communications
module “RS 485”, then the totalizer reset can also be carried out with the
auxiliary input (see page 69).
6
NO
– YES
7
Display of the actual totalizer value (HOME position).
FLOW RATE
Display of the actual flow rate.
This is particularly advantageous if the HOME position is already assigned to
other measuring variables, e.g. to a batching function.
Display:
max. 5-digit number: –99999...+99999
7
UNIT ==> FLOW RATE UNIT
Unit selection → see “FLOW RATE UNIT” function
ASSIGN LINE 1
With this function the variable is defined which should be displayed on the
upper
display line during normal operation (HOME position).
6
FLOW RATE
– TOTAL VOLUME – BATCH QUANTITY * –
BATCH UPWARDS * – BATCH DOWNWARDS * – BATCH CYCLE *
* These parameters only appear if the function “BATCH VARIABLE”
is set to “VOLUME” (see page 64).
ASSIGN LINE 2
With this function the variable is defined which should be displayed on the
lower
display line during normal operation (HOME position).
6
OFF – FLOW RATE –
TOTAL VOLUME
– TOTAL OVERFLOW –
BATCH QUANTITY * – BATCH UPWARDS * – BATCH DOWNWARDS *
BATCH CYCLE *
* These parameters only appear if the function “BATCH VARIABLE”
is set to “VOLUME” (see page 64).
Note!
Promag 33 6 Description of Functions
Endress+Hauser 67
To Next Page
Loading...
