Installation WirelessHART Fieldgate SWG70
20 Endress + Hauser
1. Switch off the supply voltage to the Fieldgate.
2. Install the antenna where it is within the antenna range of other WirelessHART
devices. See Chapter 4.1.3 "Examples of good and poor positioning" on page 18.
3. Mount the surge arrester indoors. The coaxial cable between the surge arrester and
Fieldgate may only be routed indoors.
4. Connect the antenna to the surge arrester using a coaxial cable.
5. Connect the antenna, the surge arrester and the Fieldgate to the protective grounding
as illustrated in Figure Fig. 4-4.
To Next Page
Loading...
