Commissioning WirelessHART Fieldgate SWG70
40 Endress + Hauser
7.3.4 Scanning for wireless devices in the network
After Fieldgate SWG70 has been configured, see Chapter 8.2 onwards, you may want to
scan for other devices in the network.
1. Right-click on the Fieldgate SWG70 node and select Create Network..:
– You can also click on the Create Network icon to do this.
– The Fieldgate SWG70 is put on-line and the two arrows turn green.
2. The Fieldgate CommDTM now scans the wireless network and automatically adds all
WirelessHART devices found to the network (in our case the SWA70 adapters):
NOTICE!
• If no device is found although communication has been established, check that the
adapters have been configured with the correct network identification and join key.
• It may take up to ten minutes for a wireless device to join the network after download of
the Network ID and Join Key.
• To increase the performance of a connection to an adapter it is possible to open a fast pipe.
See Chapter 8.2.3 "Operating Modes" on page 49.
To Next Page
Loading...
