WirelessHART Fieldgate SWG70 Commissioning
Endress + Hauser 35
7.1.1 Establishing the connection between the host computer and
the Fieldgate SWG70 Web server
Prerequisite
The Fieldgate SWG70 is connected to the Ethernet network. See Chapter 5.3 "Connecting
to Ethernet" on page 24.
Procedure 1. Check that the computer can reach the Fieldgate via ports 80, 443, 502, 3333 and
5094. Please contact your network administrator if necessary.
2. Note the current settings for the IP address and network/subnet mask of the computer
to restore them if necessary.
3. Change the IP address and the network/subnet mask of your computer:
– IP address 192.168.1.200
– Network/subnet mask 255.255.255.0.
4. The simplest way to check the connection is to call up the Fieldgate SWG70 Web
server. For this, enter the default IP address of the Fieldgate SWG70 in your Internet
browser: 192.168.1
5. Accept the site certificate in the dialog which now appears.
6. The Login of the Web page appears.
– To open the Fieldgate SWG70 Web page, enter the User name
(default: admin) and the Password (default: admin) and click OK.
7. If the connection to the Fieldgate Web server fails, check the following points:
– Are all the proxy servers in the browser switched off or not used for this address
range?
– Are ports 80, 443, 502, 3333 and 5094 open in all the firewalls?
– Are you using the correct Ethernet cable? See Chapter 5.3 "Connecting to Ethernet" on
page 24.
– Is the Ethernet cable correctly connected? See Chapter 5.3 "Connecting to Ethernet" on
page 24.
To Next Page
Loading...
