Endress+Hauser WirelessHART Fieldgate SWG70 - Parameterizing Fieldgate SWG70

WirelessHART Fieldgate SWG70 Commissioning
Endress + Hauser 39
7.3.3 Parameterizing Fieldgate SWG70
1. Right-click HART IP Communication and select Connect:
– The HART IP CommDTM is put on-line and the two arrows turn green.
2. Right-click on the Fieldgate SWG70 node and select Connect.
– The Fieldgate SWG70 DTM is put on-line and the two arrows turn green.
3. Right-click on the Fieldgate SWG70 node and select Online Parameterize:
– The DTM of Fieldgate SWG70 opens.
4. Expand all the submenus of the directory tree to reveal the parameter blocks. (The
"Identification" page is open in the graphic below):
– You are now ready to configure the device. See Chapter 8 "Fieldgate configuration" on
page 44.