Endress+Hauser WirelessHART Fieldgate SWG70 - Input Register

WirelessHART Fieldgate SWG70 Engineering
Endress + Hauser 75
10.3.3 Input Register
Input Register allows the Modbus mapping of Fieldgate SWG70 and the connected HART
devices. As Fieldgate SWG70 supports extended registers, values are normally assigned the
Input Registers with the reference addresses 300001 to 365536. In the case of some Mod-
bus systems values must be assigned to the holding registers with reference addresses
400001 to 465536, see Read Modbus Registers Mode in Section 10.2.1. The dialog checks
for completeness of entries (line turns red if not correctly filled out) as well as double assign-
ment to the registers.
1. Click on Engineering => Modbus Mapping => Input Register to open the dialog:
2. Click on Generate to open the Generate tab.