EnGenius DuraFon - Handset Features; System and Security Settings

~19~
the handset user’s name.
Re: Up to 32-characters can be entered.
22.
Change Pwd
a.
Change the handset password, which requires entering the Call Barring
(MENU-4-3) and Menu Display (MENU-8).
Re: Default PIN is “0000.”
23.
DTMF Duration (from web)
24.
Programmable Flash Key Timing (from web)
25.
Assign Next Handset ID for New Handsets
a.
Use a registered handset from MENU-6-1 to assign a Next Handset ID to a
new handset.
b.
If you do not assign Next Handset ID, the system will automatically assign a
handset ID to a new handset.
c.
When entering the Base Settings, a PIN is required. The Default is “0000.”
26.
Clear Handset
a.
Use a registered handset from MENU-6-2 to remove the other registered
handset, in case the other registered handset is defected.
b.
Once the other registered handset is clear, the user is able to register a
new handset in its place.
c.
When entering the Base Settings, the PIN is required. Default is “0000.”
27.
Change PIN
To change the base PIN, enter the “Base Settings” (MENU-6-3).
a.
Use a registered handset to change the PIN from MENU-6-3.
b.
The default PIN is “0000.”
c.
When entering the Base Settings, the PIN is required. The default PIN is
“0000.”
28.
Auto Hang Up Feature (from web)
a.
From Web, “System-Base Settings-Auto Hang up” to turn On/Off this auto
hang up feature.
b.
If turning On the feature, the handset will automatically hang up the call
when the far-end hangs up its call.
29.
Mic Gain
Change the handset microphone gain based on the handset’s use in different
environments – Quiet, Normal and Noisy environment.