10
GB
Connecting the sauna lamp
The sauna lamp must be weatherproof pro-
tected (IPx4) and resistant to the ambient
temperature.
The sauna lamp can be mounted at any
point, but never near to rising hot air from
the heater and as far as possible from the
installation position of the IR lamp (may not
in the direct beam).
Connecting a fan
The fan must be weatherproof protected
(IPx4) and resistant to the ambient tempera-
ture.
The fan can be mounted at any point, but
never near to rising hot air from the heater
and as far as possible from the installation
position of the IR lamp (may not in the direct
beam).
LSG
Connecting a colored light
Connecting a GSM module
Connecting a power control
unit
Details can be found in the colored light as-
sembly instructions.
Details can be found in the GSM module as-
sembly instructions.
Details can be found in the power control
unit assembly instructions.
Connecting the remote but-
ton
Details can be found in the remote button
assembly instructions.
Details can be found in the switch module
assembly instructions.
Connecting the phase sec-
tion module for LED/spot
lights
Connecting the switch mod-
ule for energy-saving lamps
Details can be found in the switch module
assembly instructions.
Only ohm resistive load, we
recommend to use special bulbs
like baking oven bulbs.Other bul-
bs, like energy-saving-lamps can
destroy the control unit.
To Next Page
Loading...
Need help?
General
