EOS EMOTEC DC 9000 - Deactivating the Time Preselection; P2 Heating Time Limitation

26
GB
The heating time is limited to 6 hours by de-
fault upon delivery. After this time has elapsed
your sauna will switch off automatically.
In order to set the maximum heating time,
press the "Mode" key and then the "
" key
until the heating time symbol and "P2" ap-
pear.
Conrm with the "Mode" key.
Using the "
" and " " keys, you can now
set the required value. The time is set in
10-minute steps.
Conrm the entry by continuously pressing
the "Mode" button until the newly set value
ashes on the display.
Afterwards, the "P2" is briey shown until
the display returns to the original state. The
new value for the maximum heating time is
now stored.
P2 Heating time limitation
P 2
06:00
03:00
03:00
In order to deactivate the time preselection, please press the "On/Off " button. Then the
sauna heater will be switched on, By pressing the "On/Off " button again the sauna heater
is switched on.
Deactivating the time preselection
This program step will only appear if the device has not been set for the
"Wochentimer" mode during installation.