18
GB
Preset parameters
Finnish sauna mode
After switching on, the display alternates
between showing the current time and the
remaining heating time.
Heating time
The factory-default heating time limitation
is pre-set to 6 hours. This means that the
unit switches off after 6 hours due to safety
reasons.
The display alternates between showing the
current time and the remaining heating time
during active heating.
20:03
05:58
05:58
Temperature display
During the heating phase plus approx. 15 min-
utes, the thermometer symbol continues to ll.
The control phase begins once the end tem-
perature is reached. The thermometer lling
now continually shows the temperature on
the sensor.
Heating phase Control phase
90
Actual - target temperature
By pressing the “Up ” button for more than
3 seconds, you can show the actual tempera-
ture on the heater.
If a bench sensor is installed, you can show
the temperature at bench level by pressing the
“Down
” button for more than 3 seconds.
To Next Page
Loading...
