Programs
Centrifuge 5702/5702 R/5702 RH
English (EN)
44
7.3 Calling up a program
You can call up stored programs.
Prerequisites
• Rotor stop.
Press the prog 1 key or prog 2 key to call up a program.
• The program key lights up blue.
• The display shows the parameters of the program.
7.4 Editing programs
You can overwrite stored programs.
Prerequisites
• The program has been created and stored.
• The program has been called up. The program key prog 1 or prog 2 lights up blue.
1. Press the key again on which the program has been stored.
The program key does not light up any more.
The display shows the centrifugation parameters.
The centrifugation parameters can be adjusted.
2. Change the centrifugation parameters.
3. Store the program on the old program slot. Press the prog 1 key or prog 2 > 2 s to do this.
• A signal sounds.
• The program key does not flash any more. The program key lights up in blue.
• The parameters of the program are saved.
7.5 Deleting programs
Programs 1 and 2 cannot be deleted. The programs can be overwritten.
7.6 Exiting the program
Prerequisites
• The program has been called up. The program key prog 1 or prog 2 lights up blue.
1. Press the prog 1 key or the prog 2 key to exit the program.
• The program key does not light up any more.
• The display shows the centrifugation parameters.
• The centrifugation parameters can be adjusted.
If a program is loaded, the parameters cannot be changed. The following text appears in the
display - Pr 1 for program 1 or Pr 2 for program 2.
To Next Page
Loading...