196
Functions of the Control Panel
If you need to configure the printer settings, first switch to the
GL/2 emulation mode, then change the settings using the printer
driver, or the control panel menus.
Note:
Settings or data saved in the printer’s RAM (such as downloaded fonts)
may be erased when you change the emulation mode.
GL Mode
Specifies whether the printer uses a direct emulation of the GL/2
plotter language, or the HP LaserJet 4 emulation of GL/2.
Scale
Specifieswhetherthe output from the software isscaled. The scale
factor is based on the output paper size of the application.
Origin
Specifies whether the logical origin of the “plotter” is the corner
or the center of the paper.
Pen
Allows you to choose a pen which you can then set the thickness
forinthePen0through6item.TheLJ4GL2modesupportstwo
pens (0 and 1), while the GLlike mode supports seven pens (0
through 6).
End
Specifies the way in which lines end.
Join
Specifies the way in which lines are joined.
Orientation
GLlike
offers landscape only
LJ4GL2
offers landscape and portrait
To Next Page
Loading...
