Epson AcuLaser C4000 - Replacement Messages

250
Maintenance and Transportation
Replacement messages
When you see the following messages on the LCD panel, or when
notified by the EPSON Status Monitor 3, it is time to replace the
indicated consumable products. You can continue to print for a
shorttimeafter a message appears,butEPSONrecommendsearly
replacement to maintain print quality and extend the life of your
printer.
* The letters C, M, Y, and K appear in this position, indicating the color of the toner
to be replaced. For example, the message
Y Toner Low
means that the amount of
toner remaining in the yellow toner cartridge is low.
Note:
❏ Do not replace the toner cartridge when the
XXXX Toner Low
message appears. Toner remaining in the toner cartridge may spill
out if you remove the toner cartridge to replace it. Replace the toner
cartridge when the
XXXX Toner Out
message appears.
❏ If you replace the toner cartridge before the
XXXX Toner Out
message appears, it is not detected as a new toner cartridge and the
XXXX Toner Low
warning may not be cleared.
❏ To clear the warning, select
Clear Warning from the control
panel’s Reset Menu.
LCD Panel
Message
Description
XXXX* Toner Low The amount of toner remaining in the indicated toner
cartridges is low.
Worn
Photoconductor
The photoconductorunit has reached theend of its service
life.
Worn Fuser The fuser unit has reached the end of its service life.
Worn Transfer Unit The transfer unit is near the end of its service life.